Attach the mounting bracket to the anchors using the four 6-AB x 1 in.Screw the four anchors into the drywall using the center marks as a reference.Refer to the image below for the required mounting holes. Use one of the anchors to make a center mark in the drywall through the four 2-gang openings in the template.Align the mounting bracket with the cutout and ensure it is level.Ensure the template is level prior to cutting the hole. Using the inside of the mounting bracket as a template, cut aĢ–1/8 x 3‑5/8 in.To install the mounting bracket into drywall: Using this hardware will ensure that the bracket is completely flush with the touch screen to provide maximum magnetic force. Mounting hardware is provided with the touch screen for drywall installations without an electrical box. Insert the screws through the center openings in the left and right sides of the mounting bracket. installations (not pictured), use the two M3.5 x 25 mm screws to attach the mounting bracket to the electrical box. For European installations, use the four M3 x 16 mm screws.installations, use the four 6‑32 x 3/4 in. installations, use a #1 Phillips screwdriver. installations, use a #2 Phillips screwdriver. The touch screen also installs into drywall. electrical box, a 2‑gang European electrical box, or a 2‑gang U.K. The TSW‑770 and TSW‑1070 install over a standard 2‑gang or 3‑gang U.S. Install the TSW-770/TSW-1070 Mounting Bracket Ensure the front of the TSW‑UMB‑70 is level, and then tighten the two bracket screws.Push the rear half of the mounting bracket back so that it is seated behind the mounting surface completely.Install the TSW‑UMB‑70, bottom side first, into the opening.Loosen the two screws on the TSW‑UMB‑70 mounting bracket.Create an opening in the surface by tracing the cutout opening with an appropriate drywall saw.TSW‑UMB‑70‑PMK mounting bracket as a cutout template by turning the bracket to face the wall, ensuring it is level, and tacking it to the wall temporarily with finishing nails (not included) through the smaller holes around the cutout opening. To install the TSW-570 mounting bracket in postconstruction applications: (305 mm) in the wall cavity above and below the touch screen for heat dissipation. NOTE: Allow an air gap of at least 12 in.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |